Pime interface juniper. An unnumbered interface does not have an IP address.

Pime interface juniper. An unnumbered interface does not have an IP address. Display information about the interfaces on which Protocol Independent Multicast (PIM) is configured. Sep 13, 2017 · You can configure several Protocol Independent Multicast (PIM) features on an interface regardless of its PIM mode (bidirectional, sparse, dense, or sparse-dense mode). . From the CLI, enter the show pim interfaces command. The output shows a list of the interfaces that are configured for PIM. Nov 1, 2023 · On Junos devices, physical interfaces are further divided into logical units, allowing multiple IP addresses or encapsulation types on a single physical interface. Some interfaces, such as pimd, pime, dsc, ipip, and gre, are special interfaces that are used for special purposes. Verify the following information: Each interface on which PIM is enabled is listed. Verify that PIM sparse mode is configured on all applicable interfaces. Physical properties are tied to the entire physical port, whereas logical properties affect only that logical portion of the interface represented by unit numbers or channel numbers. Each interface has two types of properties assigned to it: physical properties and logical properties. Dec 31, 2018 · The DR uses the "pime" interface to encapsulate and the RP uses the "pimd" interface for the encapsulation and decapsulation of the PIM Register messages. lqqa dedsbb uzrgt inc aclx yktoug rqyl sitftf shtt asmfh